ESP8266 ESP-12F 7-28V 4Ch 30A Wifi Relæ Module har en indgangs spænding på 7-28V, og bliver kontrolleret fra ESP-12 chippen. Perfekt til alle IoT projekter.
Tekniske detaljer:
Mature and stable esp-12f WiFi module on board, large capacity 4m Byte Flash.
I / O port of WiFi module and UART program download port are all led out, It is convenient for secondary development.
The power supply mode supports dc7-28v / 5V.
On board WiFi module RST reset button and a programmable key.
Esp-12f supports the use of eclipse / LDE and other developers p
rovide the reference program for Arduino development environment.
On board 4-way 5V / 30A relay, output switch signal, to
control the load whose working voltage is within AC 250V / DC 30V.
On board power indicator, 1 programmable led and relay indicator.
Board size: 122.5 * 87mm
Weight: 160g
Installere ESP package (Arduino IDE)
- Åben Arduino IDE (Download her)
- Klik “Fil/Egenskaber”
- Indtast dette link i feltet “Additionel Board Manager URL’s”
- Link “http://arduino.esp8266.com/stable/package_esp8266com_index.json“
- Klik OK
- Åben “Værktøj/Board/Boards manager” (Lad programmet opdatere)
- Find “ESP8266” og installere
- Klik derefter “Værktøj/Board” og find (NodeMCU 0.9 (ESP-12 Module))
- “Værktøj/Programmer” skal være “AVR ISP”
- Du er nu klar til at sende en kode
Program Upload: (Arduino IDE)
Da dette modul ikke har en USB interface, skal der bruges en “TTL Serial Adapter Module” som sender programmet over i chippen. Du kan købe den her:
Inden koden kan uploades skal IO0 forbindes til GND imens koden uploades.
Relay output:
NC: normally closed end, the relay is short circuited with com before closing and suspended after closing.
COM: public end.
No: normal opened end, the relay is suspended before closing, and it is short circuited with com after closing.
Kontakt os
Du er altid velkommen til at kontakte os på [email protected], eller sende os en besked via messenger (Klik her) og vi vil hjælpe dig.
Anmeldelser
Der er endnu ikke nogle anmeldelser.